Before installing the pole, visually inspect the weld of the solar street lamp post with uniformity and no welding. There should be no drum, pinhole, crack or leak spray in the spray. The straightness error of the solar street lamp shaft is less than 3%.
When installing the solar street light pole, try to prevent the surface coating from being injured or cut. It is strictly forbidden to use the steel wire rope sleeve to straighten or throw it down from the vehicle.
The solar street light poles should be installed straight and the vertical deviation should be no more than half the diameter of the lamp tips. The solar street light poles should be set on a line parallel to the longitudinal axis of the road, and the lateral displacement should be no more than half the diameter of the root.
Before the light source is installed, it is necessary to check whether it is normal, so as to avoid unnecessary troubles after installation that may be damaged in transit.
The installation of the luminaire should be straight and perpendicular to the longitudinal axis of the road. The error is not more than 3 degrees. There is no skew after visual inspection.
When the solar street light pole is installed, the bolts of each part should be reinforced with a flat spring pad. After tightening, the bolt exposed nut should not be less than two pitches.
The bolts of the lamp cap and the lamp body must be fastened, and the part that can be rotated by the wind pressure should be reinforced.
